您好,欢迎光临!莱州聚峰机械有限公司网站!

莱州聚峰机械有限公司

定制咨询热线:400-879-1999

常见问题

首页>>资讯中心>>常见问题一辆合格的搅拌车需要满足什么标准?
联系我们
莱州聚峰机械有限公司

联系人:刘经理

电话:400-879-1999

地址:山东省莱州市206国道与308省道交叉口东南50米

一辆合格的搅拌车需要满足什么标准?

来源:https://www.zishangliaojiaobanji.cn 日期:2020-04-23 发布人:admin
概述:一、整车的外廓尺寸应符规范的规则。并按同意的产品图样及技术文件制造。1、 The overall dimensions of the whole vehicle sh
一、整车的外廓尺寸应符规范的规则。并按同意的产品图样及技术文件制造。
1、 The overall dimensions of the whole vehicle shall conform to the rules of national specifications. And manufacture according to the agreed product drawings and technical documents.
二、外购件、外协件均应有制造厂的产品合格证,并契合相关规范的要求,经拌和车生产厂查验合格后方可装配。
2、 Purchased parts and outsourced parts shall have the product certificate of the manufacturer and meet the requirements of relevant specifications. They can be assembled only after they are inspected and qualified by the mixer manufacturer.
三、拌和车的厂定总质量不得超越底盘的许用值,转向轴(轮)载质量和侧倾安稳角应契合GB7258的规则。
3、 The plant determined maximum total mass of the mixer shall not exceed the maximum allowable value of the chassis, and the steering shaft (wheel) load mass and roll angle shall conform to the rules of GB7258.
点击进入看图评论
Click to view the comments
四、焊缝应均匀、平直。无漏焊、裂纹、央渣、表面应无毛边,包砂等现象。
4、 The weld shall be even and straight. There shall be no missing welding, crack, slag, rough edge and sand inclusion on the surface.
中科搅拌车
五、一切显露黑色金属表面均应作防锈处理。表面装修漆应美观大方,契合GB7258的规则。
5、 All exposed ferrous metal surfaces shall be treated for rust prevention. The surface decoration paint shall be beautiful and generous, and conform to the rules of GB7258.
六、从进料到运送卸料完毕,答应的更长时刻为90mh,且拌和筒按规则连续运输不大于300转。拌和车行进时,车速不得超越如50km/h
6、 From the time of feeding to the completion of transportation and unloading, the maximum time allowed is 90mh, and the continuous transportation of mixing drum shall be no more than 300 revolutions according to the rules. The maximum speed of mixing vehicle shall not exceed 50km / h
七、装入预拌混凝土在规则的搅动转速和运送时刻运送到交贷地点后,泥凝土质量应符国标要求。
7、 After the ready mixed concrete is loaded and transported to the place of delivery at regular agitation speed and delivery time, the quality of the clay shall meet the requirements of the national standard.
八、进料斗出口尺寸不小于历650mm,距地面高度应不大于3.8m。
8、 The outlet size of the feed hopper shall not be less than 650mm, and the height from the ground shall not be more than 3.8m.
九、水泥拌和车的出料速度不小于0.65m3/min,出料剩余率小于2-5%。拌和车的进料速度不小于2.7m3/min
9、 The discharging speed of cement mixer shall not be less than 0.65m3/min, and the residual rate of discharging shall be less than 2-5%. The feeding speed of mixer shall not be less than 2.7m3/min
十、运送应装置结实。各衔接部分部件不该有损坏、变形等现象,不该有上车与底盘偏离原先的固定装置的情况。
10、 The delivery shall be firm. The connecting parts shall not be damaged or deformed, and the upper vehicle and chassis shall not deviate from the original fixed device.
十一、车在总质量状态下,以20km/h的速度府能通过14%的坡道外溢。
11、 Under the condition of maximum total mass, the vehicle can pass 14% of the ramp at the speed of 20km / h.
十二、制动功能府契合国标规则。行进车外噪声应符国标要求。
12、 The brake function conforms to the national standard rules. The noise outside the traveling vehicle shall meet the requirements of the national standard.
十三、整车的各项密封功能杰出,各密封面、管接头及一切衔接部位均不得有渗油漏气的现 象。
13、 The sealing functions of the whole vehicle are outstanding, and the sealing surfaces, pipe joints and all connecting parts shall be free of oil leakage.

阅读/ Recommended reading

小型混凝土搅拌机生产效率高,搅拌质量好,操作简单,重量轻,自动化程度高,操作方便、移动方便、生产效率高等优点,所以使用的人是越来越

解析小型搅拌机的结构及各部分功... 2022-12-21
小型搅拌机整体生产效率受影响的... 2022-12-19
自上料搅拌车的罐体内部部件剖析 2022-12-16
自上料搅拌车离合器活塞密封性的... 2022-12-14
搅拌车结构会根据不同的路况进行... 2022-12-05
利用光照法观察搅拌机机油颜色是... 2022-12-02
混凝土搅拌机的常见三大故障 2022-11-30
自上料搅拌车预防漏油的六大措施 2022-11-28

截屏,微信识别二维码