As long as the user has certain professional maintenance knowledge, it will be of great help in use. But mechanical oil leakage is a very common problem, but today to teach you these moves, automatic feeding mixer "stop oil" has these 8 points is enough!
The service time is too long and the oil seal is normal wear condition. Solution: replace the oil seal with a new one.
The oil has not been replaced for a long time, the quality of the filter element is not up to standard, and the oil is too dirty, thus speeding up the wear of the oil seal. Solution: replace hydraulic oil and filter element as soon as possible.
The balance of the transmission shaft fails and the swing momentum is large, which causes the eccentric wear of the oil seal of the spindle swing. Treatment plan: correct and replace the rotating shaft in time.
The deterioration and emulsification of hydraulic oil result in the decrease of lubricating performance and the acceleration of oil seal wear. Solution: replace the hydraulic oil and filter element as soon as possible, and clean the system if it is serious.
The pump bracket is loose, the pump is opened, and the pump fixing bolt is loose, which causes the overall shaking of the hydraulic pump and the wear of the oil seal. Solution: frequently check and eliminate the possible faults in the automatic feeding mixer, and prevent and avoid the occurrence of faults.
The oil return of the automatic feeding mixer system is not smooth, and the oil return pipe and radiator are blocked, which leads to the increase of pressure in the motor housing and the oil seal leakage. Solution: remove the blockage and keep the return oil circulation unobstructed.
The radiator does not dissipate heat, which results in the oil temperature being too high, the viscosity and lubricity decreasing, the oil seal overheating and sealing failure. Solution: eliminate the radiator failure, cooling the system to avoid pump motor wear. In serious cases, the engine should be shut down and the pump motor and radiator shell should be flushed with water to achieve cooling effect.
In winter, if the preheating is insufficient, the oil temperature is too low and the oil and oil seal do not reach the ideal working temperature. Treatment plan: stop the tank at idle speed for 10min to 20min when starting, and then turn the tank to work after the oil temperature is normal.
The oil seal at the shaft end of the hydraulic pump of the automatic feeding mixer is a vulnerable part. If the operation is carried out in strict accordance with the relevant specifications, in fact, many oil leakage phenomena will be effectively prevented. In case of oil leakage, it is necessary to find out the specific causes and deal with them calmly.
With the summary from the charging mixer, we hope to help our customers. If you have any questions or ask for help, please click our website: https://www.zishangliaojiaobanji.cn Or call consultation, we will try our best to solve it for you
推荐阅读/ Recommended reading
- 去除自上料搅拌机车身刮痕的方法 2021-03-02
- 搅拌车底盘对小型混凝土搅拌车的... 2021-02-26
- 混凝土搅拌车固态油泥清理应该注... 2021-02-22
- 自上料搅拌机液压系统温度过高如... 2021-02-20
- 自上料搅拌机使用前后注意事项 2021-02-15
- 自上料搅拌一体车的维修情况 2021-02-10
- 自动上料搅拌机小型发动机的作用 2021-02-10
- 混凝土搅拌车省油怎样？ 2021-02-03
罐体容积大不只影响购车的本钱，还影响车辆功用，行车安 全系数低，罐体越大重 心越高，车辆稳定性差。所以车主朋友们应根据搅拌车作业的