概述：1、自上料搅拌车应设置在平整的方位，用方木垫起前后轮轴，使轮胎搁高架空，避免在开动时发作走动。1 The self loading mixer should
1. The self loading mixer should be set in a flat position, and the front and rear axles should be padded with square wood to make the tires empty, so as to avoid moving when starting.
2. Grade leakage protection should be implemented for the charging mixer. After the power supply is connected before going to work, it is necessary to check carefully, and it can be used only after the empty car is tested as qualified. During the trial operation, it is necessary to check whether the speed of mixing drum is appropriate. Under normal conditions, the speed of empty truck is slightly faster than that of truck (after loading). If there is a large difference, the share of driving wheel and driving wheel shall be adjusted.
3. The rotation direction of mixing drum shall be in accordance with the direction indicated by the arrow. If not, the motor wiring shall be corrected.
4. Check whether the transmission clutch and brake are sensitive and reliable, whether the wire rope is damaged, whether the track pulley is outstanding, whether there are obstacles around and the smoothness of various parts.
5. After starting up, often pay attention to the concrete mixer parts of the operation is normal. When stopping the machine, often check whether the blade of the concrete mixer is bent and whether the screw is broken or loose.
6. When the concrete mixing is finished or it is estimated to stop for more than 1 h, in addition to discharging the remaining materials, stone and water shall be poured into the shaking drum, and the machine shall be started to roll, and the mortar adhered to the barrel shall be washed and cleaned, and then all the mortar shall be discharged. There should be no water in the barrel to avoid rust of the barrel and blade. At the same time, the ash accumulated outside the mixing drum should be sorted out to keep the machinery clean.
7. After work and when the machine is not in use, the switch should be switched off and the switch box should be locked to ensure safety.
推荐阅读/ Recommended reading
- 防止自动搅拌车我给您妙招 2021-01-13
- 自上料搅拌车六项操作主要事项 2021-01-11
- 小型混凝土搅拌车卸料注意事项 2021-01-08
- 如何让自上料搅拌车进行安全运转？ 2021-01-05
- 自上料搅拌车噪音大容易出现故障... 2020-12-30
- 自拌混凝土搅拌车下雨天怎么注意？ 2020-12-29
- 混凝土自动上料搅拌车生产的条件 2020-12-25
- 小型搅拌机装置性能的介绍 2020-12-22
首先:我们需要对需要喷绘安装的场地进行测量和现场调查First of all, we need to measure and investigate the installation si