您好,欢迎光临!莱州聚峰机械有限公司网站!

莱州聚峰机械有限公司

定制咨询热线:400-879-1999

新闻资讯

首页>>资讯中心>>新闻资讯自上料搅拌车六项操作主要事项
联系我们
莱州聚峰机械有限公司

联系人:刘经理

电话:400-879-1999

地址:山东省莱州市206国道与308省道交叉口东南50米

自上料搅拌车六项操作主要事项

来源:https://www.zishangliaojiaobanji.cn 日期:2021-01-11 发布人:admin
概述:一轻:自上料搅拌车工作时,脚跟靠近驾驶室地板,脚踏板和油门踏板保持平行,并且踩下油门踏板。Yiqing: when the self loading mixer
一轻:自上料搅拌车工作时,脚跟靠近驾驶室地板,脚踏板和油门踏板保持平行,并且踩下油门踏板。
Yiqing: when the self loading mixer works, the heel is close to the floor of the cab, the pedal and the accelerator pedal are parallel, and the accelerator pedal is depressed.
二稳:在自上料搅拌车运行期间,节气门应始终保持稳定。在正常运行条件下,节气门开度应为70%左右。
Secondary stability: during the operation of the self feeding mixer, the throttle valve should always be stable. Under normal operating conditions, the throttle opening should be about 70%.
三分隔:在自上料搅拌车运行期间,脚踏板应与制动踏板分离,并平放在驾驶室地板上。切勿踩刹车踏板。自上料搅拌车经常在不平坦的建筑工地上工作。如果脚始终在制动踏板上,则身体的上下运动将导致驾驶员不小心踩踏制动踏板。在正常情况下,有必要通过控制节气门减速度来控制发动机状况和换档。这不仅避免了由于频繁制动引起的制动系统过热,而且还为自动加料搅拌机的快速提速带来了便利。
Three separation: during the operation of the self feeding mixer, the pedal should be separated from the brake pedal and placed flat on the floor of the cab. Do not step on the brake pedal. Self feeding mixer often works on uneven construction sites. If the foot is always on the brake pedal, the up and down movement of the body will cause the driver to step on the brake pedal carelessly. Under normal conditions, it is necessary to control the engine condition and shift by controlling the throttle deceleration. This not only avoids the overheat of the braking system caused by frequent braking, but also brings convenience for the rapid speed-up of the automatic feeding mixer.
自上料搅拌机
四勤:在自上料搅拌车工作时,尤其是在铲斗工作时,在节流阀稳定的情况下,应通过周期性地拉起升降杆和转动杆来充分铲起铲斗中的物料。提升和转动铲斗控制杆的周期性拉动称为“努力”。这个过程非常重要,对燃油消耗有很大影响。
Si Qin: when the self loading mixer is working, especially when the bucket is working, and the throttle valve is stable, the lifting rod and rotating rod should be pulled up periodically to fully shovel the materials in the bucket. The periodic pull of lifting and rotating the bucket control lever is called effort. This process is very important and has a great impact on fuel consumption.
五协调:协调是提升和旋转控制杆的有 机协调。自上料搅拌车的一般铲铲过程是先将铲斗放在地面上,然后平稳地驱动物料堆。当铲斗平行于物料堆铲起并遇到阻力时,应遵循先升高臂然后缩回铲斗的原理。这样可以有 效避免铲斗底部的阻力,从而可以充分发挥教大的挖掘力。
Five coordination: coordination is the organic coordination of lifting and rotating control rod. The general shovel process of self loading mixer is to put the bucket on the ground first, and then drive the material pile smoothly. When the bucket is parallel to the material stack and meets resistance, the principle of first raising the arm and then retracting the bucket should be followed. This can effectively avoid the resistance at the bottom of the bucket, so as to give full play to the digging force.
六禁止:一是严格禁止轮胎打滑。当自上料搅拌车工作时,在加速器被 迫遇到阻力时轮胎经常会打滑。这种现象通常是由驾驶员的不当操作引起的,这会增加燃油消耗并损坏轮胎。其次,严禁倾斜后轮。由于自上料搅拌车的挖掘力大,因此驾驶员通常会在操作过程中挖掘坚固的原始土壤和石质山丘。如果操作不当,则两个后轮易于抬离地面。
Six prohibitions: first, it is strictly forbidden to skid tires. When the self feeding mixer is working, the tire often slips when the accelerator is forced to encounter resistance. This phenomenon is usually caused by improper operation of the driver, which will increase fuel consumption and damage the tires. Second, do not tilt the rear wheels. Due to the large digging force of the self loading mixer, the driver usually excavates solid original soil and rocky hills in the process of operation. If not handled properly, both rear wheels are easy to lift off the ground.
该倾斜动作的着陆惯性将导致铲斗的叶片断裂且铲斗变形;当后轮向高位倾斜时,也容易引起前后框架和其他结构的焊 接破裂,甚使板破裂。三是严格禁止撞桩。为了铲入普通物料,可以在齿轮II中操作自动上料搅拌机。严禁在II档以上的齿轮上惯性撞击物料堆。正确的方法应该是通过在铲斗接近库存时及时将档位切换I来完成铲土过程。
The landing inertia of the tilting action will lead to the blade fracture and bucket deformation; when the rear wheel tilts to a high position, it is also easy to cause the welding fracture of the front and rear frames and other structures, or even the plate fracture. Third, pile collision is strictly prohibited. In order to shovel ordinary materials, the automatic feeding mixer can be operated in gear II. It is strictly forbidden to impact the stack of materials on gears above gear II. The correct method should be to complete the shovel process by changing the gear to I in time when the bucket is close to the stock.
本文来自:自上料搅拌机更多的内容请点击:https://www.zishangliaojiaobanji.cn我们将会为您提问的问题提供一个满意的服务,欢迎您的来电!
This article is from: self feeding mixer. For more information, please click: https://www.zishangliaojiaobanji.cn We will provide a satisfactory service for your questions, welcome your call!

阅读/ Recommended reading

小型混凝土搅拌机生产效率高,搅拌质量好,操作简单,重量轻,自动化程度高,操作方便、移动方便、生产效率高等优点,所以使用的人是越来越

解析小型搅拌机的结构及各部分功... 2022-12-21
小型搅拌机整体生产效率受影响的... 2022-12-19
自上料搅拌车的罐体内部部件剖析 2022-12-16
自上料搅拌车离合器活塞密封性的... 2022-12-14
搅拌车结构会根据不同的路况进行... 2022-12-05
利用光照法观察搅拌机机油颜色是... 2022-12-02
混凝土搅拌机的常见三大故障 2022-11-30
自上料搅拌车预防漏油的六大措施 2022-11-28

截屏,微信识别二维码