小型搅拌机的使用避免不了会涉水，这个情况下需要做好相关的准备工作，不然很容易就会给设备带来不可磨灭的损坏，那么小型搅拌机面对涉水情况如何进行处理？

　　The use of small mixer can not avoid wading. In this case, relevant preparations need to be made, otherwise it is easy to bring indelible damage to the equipment. Then how to deal with the wading situation of small mixer?

　　小型搅拌机在行驶时，在路上遇到了水。，减速或停下来观察。只要水位达到保险杠或轮胎的三分之二，涉水就有一定的危险。快速的速度增加了小型搅拌机的实际水深，导致雨水从机舱或底盘进入驾驶室。您应避免与大型车辆相反的方向行驶。如果通过观察，水位比较高，尽量绕过，不要强行通过。

　　The mini mixer was running and it hit water on the road. First, slow down or stop and observe. As long as the water level reaches two-thirds of the level of the bumper or tire, the wading is somewhat dangerous. The fast speed increases the actual water depth of the small mixer, causing rain to enter the cab from the cabin or chassis. You should avoid driving in the opposite direction to large vehicles. If the water level is high through observation, try to bypass, do not force through.

　　小型搅拌机涉水时除了要保持低速外，还要不要停车，不要换档，不要收回油门，尽量不要加速。低档、中、高油门应匀速通过，不能快速通过大浪或水花。

　　In addition to keeping a low speed when wading in the water, the small mixer should not stop, not change gears, not withdraw the throttle, and try not to accelerate. Low, medium and high throttle should pass at a uniform speed, not fast through big waves or spray

　　小型搅拌机在水中熄火后，不得立即启动，而应尽快采取措施，将小型搅拌机拖到水少的地方。小型搅拌机发动机的进水是一个很严重的问题。水可以从进气阀通过空气滤芯进入，然后通过进气管进入气缸体。

　　After the small mixer is flameout in water, it should not be started immediately. Measures should be taken as soon as possible to drag the small mixer to a safe place with less water. Water intake in small mixer engines is a serious problem. Water can enter from the intake valve through the air filter element, and then through the intake pipe into the cylinder block.

　　此时，不要试图启动小型搅拌机发动机，否则极有可能造成发动机曲轴、连杆等重要部件变形，造成小型搅拌机发动机抖动，严重的零件会损坏。关闭水中的火焰很可能导致小型搅拌机发动机进入水中。熄火后只能挂中性拖车去维修店清洗。

　　At this point, do not try to start the small mixer engine, otherwise it is very likely to cause the engine crankshaft, connecting rod and other important parts deformation, resulting in small mixer engine shake, serious parts will be damaged. Turning off the flames in the water is likely to cause the small mixer engine to enter the water. After flameout can only hang neutral trailer to repair shop cleaning.

　　小型搅拌机涉水后，应及时刹车片的水分，尤其是带鼓式制动器的小型搅拌机，否则小型搅拌机涉水后会失去制动，造成严重的危险或事故。

　　After wading, the moisture of brake pad should be removed in time, especially the small mixer with drum brake, otherwise the small mixer will lose its braking after wading, causing serious danger or accident.

　　具体操作是：在低速行驶时，踩油门，轻踩刹车。没有双脚的人可以多次踩刹车。这时候要注意速度慢。反复多次，小型搅拌机的制动鼓和刹车片通过摩擦发热，使水分蒸发排出。

　　Specific operation is: when driving at low speed, step on the accelerator and lightly step on the brake. People with no feet can apply the brakes more than once. Be careful to slow down at this point. Over and over again, the brake drum and brake pads of the small mixer heat up by friction, allowing water to evaporate and drain out.

　　所以说，司机涉水行车时，要正确操作小型搅拌机，不恰当的操作不仅让小型搅拌机无法通过积水地段，还会造成严重的故障隐患。要了解更多注意事项就来这里www.zishangliaojiaobanji.cn咨询吧。

　　Therefore, when the driver wades through the water, it is necessary to operate the small mixer correctly. Improper operation will not only make the small mixer unable to pass through the water area safely, but also cause serious hidden trouble. To learn more attention here www.zishangliaojiaobanji.cn consulting.